Files
nixpkgs/nixos/doc/manual/configuration/ad-hoc-network-config.section.md
Dark Steveneq 646b892680
Some checks failed
Periodic Merges (6h) / master → staging-nixos (push) Failing after 12m50s
Periodic Merges (6h) / master → staging-next (push) Failing after 12m54s
Periodic Merges (24h) / merge-base(master,staging) → haskell-updates (push) Failing after 11m54s
Periodic Merges (6h) / staging-next → staging (push) Failing after 12m13s
Periodic Merges (24h) / staging-next-25.05 → staging-25.05 (push) Failing after 13m24s
Periodic Merges (24h) / release-25.05 → staging-next-25.05 (push) Failing after 14m28s
push sheeet
2025-10-09 14:15:47 +02:00

418 B

Ad-Hoc Configuration

You can use to specify shell commands to be run at the end of network-setup.service. This is useful for doing network configuration not covered by the existing NixOS modules. For instance, to statically configure an IPv6 address:

{
  networking.localCommands = ''
    ip -6 addr add 2001:610:685:1::1/64 dev eth0
  '';
}